The pictrue is schematic of LTM4609 evalutaion kits, Can I use a DAC such as AD5696 between R5 and R9 to program the output of LTM4609?
I have a question AD5696 UG-532.
I see that AD5696 GAIN and RSTSEL Pin is connect to VLOGIC or GND.
If i want to connect VLOGIC , Pull-up resistor is pull-up resistor necessary?Is there recommendation of pull-up resistor?
Recently i got a power up issue of a external reference circuit for AD5696, it resulted in a lower then expected reference voltage.
The reason for this was the Vref-Input of AD5696. It actually started to output 2.4V a few ms earlier then the reference…
I would like to confirm a thing. Is it possible for you to check?
I think CPU should be master, DAC should be slave.
During READ OPERATION, master and slave are changed.
According to the timing chart of P22 on the datasheet of AD5694R…
I bought the AD5696 evaluation board EVAL-AD5686RSDZ and control board EVAL-SDP-CS1Z,I can use AD5696R evaluation software to convert a digital quantity into analog quantity manually, but I need to convert digital quantity into analog quantity continuously…
Thank you so much for your suggestions, turns out that the reset pin was set low the entire time.
设置A，B, C，D通道各为：0.825V, 1.10V, 1.65V, 3.30V
I bought the AD5696 evaluation board EVAL-AD5686RSDZ and control board EVAL-SDP-CS1Z
,I can use ACE software to convert a digital quantity into analog quantity manually, but I need to convert digital quantity into analog quantity continuously and automatically…