The Engineering Mind
3D ToF Depth Sensing
Clock and Timing
Design Tools and Calculators
Direct Digital Synthesis (DDS)
Embedded Vision Sensing
Energy Monitoring and Metering
FPGA Reference Designs
Interface and Isolation
Low Power RF Transceivers
MEMS Inertial Sensors
Motor Control Hardware Platforms
Power By Linear
Processors and DSP
RF and Microwave
Wireless Sensor Networks Reference Library
Clock and Timing
Clock and Timing requires membership for participation - click to join
TAGS LIST: Clock and Timing
AD9508 in CMOS Single-Ended Output Configuration
AD9510 Register Configuration Reset
AD9510: datasheet appears to contradict evaluation board schematic which uses balun for single ended ref clock connection.
AD9510: Evaluation PCB
AD9510: Outputs not in Phase
AD9511: Programming the device in RESET
AD9512 evaluation board and Windows 7, 64 Bit driver issues
AD9512 evaluation software and windows 7 64bit compatibleissues
AD9512 Phase setting not working
AD9513: figure 25 full scale delay datasheet error
AD9515_power consumption with divider ratio
AD9517-1 delay to output of channel divider
AD951x: REFIN & CLK levels and FAQ "how to treat unused pins"
AD9520-3 EEPROM settings aren't loaded
AD9523-1: Can I bypass PLL1 and only use the PLL2?
AD9548 v AD9518, comparison of phase noise performance
AD9548: JTAG simulation file
AD9549BCPZ:P CMOS does not have output
AD9552 loop bandwidth and PFD rate?
ADCLK846: broadband jitter description
Additive and Absolute Jitter
Baking the AD9951A
Clock and Timing Support Community
FAQ: Does the AD9523, AD9524, or AD9523-1 have glitchless switchover?
HMC7044, HMC7043 vs LTC6952, LTC6953
Jitter over Multiple Bandwidths
LTC695x Low Frequency Phase Noise Measurement Issues
RE: AD9514 synchronisation setup and hold times of SYNCB with respect to CLK/CLKB
Want to use AD9510/11's DLD as our lock alarm, but it may not work properly if the reference disappears. Any solution?
What's the best way to connect a 3.3V CMOS clock signal to SYSCLK?
Why is the minimum Input Frequency for the Single-Ended Mode REF1 and REF2 AC-Coupled only 20MHz?
9 Apr 2018 7:42 PM
View current version
Privacy & Security Statement
Accept & Continue