The Engineering Mind
3D ToF Depth Sensing
Clock and Timing
Design Tools and Calculators
Direct Digital Synthesis (DDS)
Embedded Vision Sensing
Energy Monitoring and Metering
FPGA Reference Designs
Interface and Isolation
Low Power RF Transceivers
MEMS Inertial Sensors
Motor Control Hardware Platforms
Power By Linear
Processors and DSP
RF and Microwave
Wireless Sensor Networks Reference Library
8052 Core Products
8052 Core Products requires membership for participation - click to join
8052 Core Products Space Description
ADuC812: A/D timing
ADUC812: Battery lifetime
ADuC812: Dealing with the interface I2C
ADuC812: enter serial download mode
ADuC812: Failure in restarting
ADUC812: Failure to Reset/Download
ADuC812: Flash reliability
ADuC812: glitches on the reset line
ADuC812: How to program external code space
ADuC812: Measure ambient temperature
ADuC812: On Chip temperature sensor
ADuC812: Power down mode and choice of C compilers
ADuC812: Problems downloading to FLASH
ADuC812: PSEN pin
ADuC812: Reseting failure when downloading user program with WSD
ADuC812: serial interface
ADuC812: Status of the port on power-up
ADUC814 minimum time and level for reset
ADuC814: Digital I/O configuration
ADUC814: Internal Temperature sensor specifications
ADuC814: Temperature sensor
ADUC816: internal ADC
ADUC824/834 microconverter's temperature sensor
ADuC824: differential input
ADuC831 ADC questions
ADUC831: What is the value of internal pull-ups in ports P2 and P3?
ADUC832: How can I check if a single ADC conversion was finished?
ADUC834 : Can I run this device from split supplies, 3.3V DVDD and a 5V AVDD?
ADUC834: Can I convert a single-ended input voltage by grounding one of primary ADC diff inputs?
ADUC834: Can I use analog inputs on Port 1 pins for digital I/0?
ADUC834: Do I need external reset generator?
ADUC834: Does changing the PLL divider value via the CD bits in PLLCON affect the baud rate?
ADUC834: Driving LEDs directly from digital outputs, what pins should I use?
ADUC834: How do I configure the UART serial port at 9600/115200 baud?
ADUC834: How do I use the on-chip temperature sensor feature of the ADuC834?
ADUC834: I am changing ranges and I am seeing much more than 2uV gain mis-match. Why?
ADUC834: I want to initiate the serial downloader through the SPI port, how can I do this?
ADUC834: Impact of fast logic edges on analog performance
ADuC834: Interfacing the ADuC834 to a RTD
ADUC834: Is it possible to accidently write to security bits and prevent part entering download mode?
ADUC834: Is it possible to switch OFF the internal buffer of primary ADC?
ADUC834: Minimum and maximum external voltage references allowed by the ADuC834.
ADUC834: Overwriting the ADC factory calibration coefficients
ADuC834: pinout decriptions missing for CSP pins 28and 29
ADUC834: Should I use the internal voltage reference or an external voltage reference?
ADUC834: The reference input is differential. Can I use a single ended reference?
ADUC834: Use of PSEN pin on Microcontroller v 8051
ADuC834: Values of the internal pull up resistor
ADUC834: What are the implications of having unbuffered differential reference inputs?
ADUC834: What baud rates can be achieved?
ADUC834: What external clocks can be used? Can the PLL be bypassed?
ADUC834: What is lowest power consumption configuration for 10 hour sample conversion intervals?
ADUC834: What is the minimum time (or ADC cycles) to get a reading if the input is a step?
ADUC834: What's the difference between the INL spec and the noise spec on the ADC?
ADUC834: Why does ADC effective resolution depend on range and update rate
ADUC834: Why is there a different result when using internal voltage ref compared to external 2.5V ref?
ADuC83x: Detailed description of parallel programming mode
ADUC842 port 3 internal pull-up electrical characteristics
ADuC845 interrupt priority handling
ADUC845: Can I shut down AVdd while leaving DVdd supply on?
ADUC845: Cascading 16 bit counters T0 and T1
ADuC845: Mixing inputs
aduc845: QS Kit for development
ADuC845: Silicon revision and anomaly sheet
ADuC845: Use of P2.3 as GPIO while using SPI in master mode
ADuC847 Burnout current pinout error
ADUC847 External reference voltage range
ADuC847: Crystal start up
ADUC847: Detecting the stop condition in slave mode
ADuC847: Noise perfomance
ADuC847: Using aspire in debug run mode
ADuC848: Contents of RAM is not fully saved to EEPROM
ADUC848: Converting a small bipolar signal.
ADUC848: Is there a single device with supply range 2.7 to 5.5 V?
Aduc848: Verify in hardware that program has been succesfully load into chip
ADuC84x, tolerance of PLL output frequency
ADuC84X. About ADuC84x external memory debug
ADUC84x: What state are the port pins set to, when the device is using the factory installed bootloader?
ADUC8xx: Explain power-on configuration routine?
ADUC8xx: Setting the security bits using the single pin emulation or must I use WSD?
ADUC8xx: Troubleshooting WSD communications and download failure issues
ADUC8xx: What if power supply fails during a program or erase of the Flash/EE?
ADUC8xx: Timing for access to the data Flash/EE space and use of NOP instructions
ADUC: Addressing up to 16Mbytes of external data memory
ADUC: Should I connect devices analog and digital ground pins to separate ground planes?
ADuCxxx starter kits
Can I use EWAIT register on ADuC841?
Configuration of current source IEXC[0|1]
Does ADuC831 have an internal pull-down resistor connected to RESET pin?
Flash code security: unauthorised reading of the flash code
Function of ADC1IC and ADC0IC bit in ICON register of ADuC816
How do I migrate from ADuC812 to ADuC831 or ADu832?
How to remove DAC zero Code error
Is there a development system for ADUC836, none is listed on order guide?
Model on Eval board - flash and supply - EVAL-ADuC847
Pin compatible upgrade for ADUC836?
Process monitoring with 6 hour timing
Program halts or operates incorrectly with ADuC842 at 16.78MHz
Recommended programming socket for ADuC847
Using ADuC842 as master on a multimaster I2C bus
Using the ADUC845 Quick Start Development kit for ADUC847 and ADUC848?
What is the difference between the EVAL-ADUC841QSPZ and EVAL-ADUC841QSZ ?
What is the maximum Source current, that port P2.5 and P2.6 can deliver?
Which is the maximum value of the external clock for the PWM on ADuc848?
Why does it take the ADuC834 so long to power on?
Why is my ADuC836 slow to lock to the external crystal?
WSD error definition
Privacy & Security Statement
Accept & Continue